Close



Results 1 to 4 of 4
  1. #1
    Student
    Join Date
    Sep 2019
    Location
    The Great Northwest
    Posts
    2

    Model starts printing above bed

    I've printed a couple dozen items on my Anycubic Kossel Plus successfully. Today I tried printing a file and the extruder started laying down filament about 2" above the bed. The Cura model looked like it was sitting on the bed. I rebooted and tried a file I'd done before and it printed normally. Both files were sliced with Cura 4.2.1. What can I check to make sure the file begins on the bed?

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,801
    you need to calibrate your z axis.

    What firmnware are you using.

  3. #3
    Student
    Join Date
    Sep 2019
    Location
    The Great Northwest
    Posts
    2
    I will do the calibration but why would some prints work normally and others start high?
    The firmware is what came from the factory.

  4. #4
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,801
    could also be the slicer
    Some models aren't always flat on the 'table' before sliging.
    Could also be a dodgy sd card.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •