Results 1 to 10 of 15
Thread: Looking for PETG Tip
Threaded View
-
09-05-2019, 12:44 PM #6
- Join Date
- Jan 2019
- Posts
- 24
I want to improve strength. I'm not totally concerned about look because currently when it goes back and forth from the pillar to that front leg (with the holes in it) I end up taking a razor blade to trim off some of the stringing on the edge which I'm fine with. Infill from my original post was 80%, i'll have to get back to you on walls when i can check my settings but i'm thinking its 3? (I'm @work right now). I was just hoping for the strength I get with PLA (but i need the heat resistance of the PETG). I thickened up those pillars a little which seemed to help just a tad but the layers still dont look blended together like the body of the object. Clean up is not a real issue (this part isn't seen in its real life use) but I was just hoping to make those pillars stronger as thats where I screw goes through and is tightened down. In its current state they crush way easier than I had hoped they would.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help