Results 1 to 2 of 2
Thread: X offset question.
-
08-30-2019, 10:34 PM #1
- Join Date
- Aug 2014
- Posts
- 627
X offset question.
I am using Marlin 2.0 and I have looked and looked all over the Internet and the only thing that made sense to me was how Smoothie solves my issue but what I have a 330x330mm bed and my X Max endstop is 3mm too far over. How do I tell the ABL/Marlin/Etc... that I need the nozzle to move to 327 and go no farther over and it may fly to the left by 330mm?
Code:// The size of the print bed #define X_BED_SIZE 330 #define Y_BED_SIZE 330 // Travel limits (mm) after homing, corresponding to endstop positions. #define X_MIN_POS -3 #define Y_MIN_POS 0 #define Z_MIN_POS 0 #define X_MAX_POS 327 //X_BED_SIZE #define Y_MAX_POS Y_BED_SIZE
-
09-01-2019, 11:02 AM #2
- Join Date
- Aug 2014
- Posts
- 627
Something that should be so simple eludes me or Marlin is doing it wrong, or not at all. After stumbling onto the Smoothie site and reading how they did/do it I have to say theirs makes sense.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help