Results 1 to 10 of 10
Thread: Creatbot DX600
Threaded View
-
08-14-2019, 06:32 AM #3
- Join Date
- Aug 2019
- Posts
- 6
I do agree you can install slic3r onto something else but I was hoping whether anyone that has managed to configure the Marlin firmware to get this working. Either I buy a Rambo board to connect to the printer and configure the marlin firmware instead of wiping out the Creatbot variant board. Alternatively I can just bring in my smoothie board or Rambo board from my mendelmax.
It is a well built printer but I guess next time we probably buy something that is configurable like utilmaker or bigrep. The person that bought the creatbot has never used a 3d printer or even built one. It is a shameful that a few manufacturers chose to break the gpl especially when all the hard work put in by reprap/utilmaker.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help