Results 11 to 14 of 14
-
08-10-2019, 08:00 AM #11
- Join Date
- May 2018
- Posts
- 566
-
08-10-2019, 09:53 AM #12
-
08-10-2019, 10:54 AM #13
- Join Date
- May 2018
- Posts
- 566
-
08-21-2019, 07:35 PM #14
- Join Date
- Aug 2015
- Posts
- 256
As someone else mentioned, buy a cheap inkbird temperature controller and use it to drive a heating element (I use a cheap hair dryer set to low).
In my setup I also have an exhaust fan hooked to the cool side of the inkbird, in case it gets too hot.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion