Results 1 to 4 of 4
-
08-02-2019, 10:37 AM #1
- Join Date
- Aug 2019
- Posts
- 2
Ender 3 question - where did this come from?
I recently purchased the Ender 3... still have a lot to learn! Was printing a box for hours and when I came back to the printer I found a small rubber cover inside the box I was printing. The box was really messed up and didn't come out the way it should but the problem I have is... I don't know where this rubber cover came from and where it goes. It's about the size of a quarter and has CR engraved on one size. Can someone tell me where this cover came from? THANK YOU!!!!
-
08-02-2019, 12:21 PM #2
- Join Date
- Jun 2014
- Posts
- 887
That's a silicone cover for the heat block. It helps keep the heat in and the gobs of filament clear of the block. It still gets hot, so keep fingers clear!
-
08-02-2019, 05:08 PM #3
- Join Date
- Aug 2019
- Posts
- 2
-
09-02-2019, 06:04 AM #4
- Join Date
- Sep 2019
- Posts
- 5
I also lost it during the printing. But unlike you i never found it again... Had to order a new one from ebay :S
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help