Results 1 to 10 of 11
Threaded View
-
07-28-2019, 06:57 AM #6
What slicer are you using? I would really like to see all slicer settings. Though taking my best guess.
It appears that you are printing too hot and burning the filament reduce the Hot-end temp to 202C.
It appears that your bed adhesion is not working Clean your bed with 70% Isopropyl alcohol or higher.
Increase the print speed to 40% for the first layer then increase the speed to 60% for remaining print.
If you do not have a parts fan get on set it to about 50% after the first layer is printed.
As this is your first print I would also change your layer height to .24 this layer height is fine for a Raspberry Pi Case.Last edited by Roberts_Clif; 07-28-2019 at 07:48 AM.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help