Ender 5 suitable for ABS / HIPS printing?

[Roberts_Clif]

Hello;

I have printed with a Prusa i3 Clone Hictop 3DP11/12 for some years now and have had no problems printing ABS.

It is much easier to print ABS when using an enclosure. I basically made a simple enclosure using a single sheet of particle board and Clear plastic sheets.

The Twins 2.jpg

Taking a sheet of particle board and cutting it into 5 pieces and fitting them together into a box with one open side where the Clear Plastic door attach.
Now this is not a great piece of work as it slipped when being glued together a little out of square, oh well!

I still have little problems with ABS when printing real thin pieces as they are too fragile and break easily while the same print in PLA works?