Results 1 to 2 of 2
Thread: FFCP Tool 1 Failure!
Threaded View
-
07-11-2019, 10:18 AM #2
- Join Date
- May 2019
- Posts
- 16
Well, just as an experiment, I removed the extruders from the carriage, and hung them over the top of the machine, near the door to the enclosure (with the enclosure top removed) and ran a test part program, just allowing the filament to extrude freely into a coil in front of the machine. It ran the entire program with zero issues. This confirms that it is in fact a wiring issue related to the movement of the print head. My assumption is that there is either a short in a wire, or the plug connector behind the extruder stepper motor has a poor connection. I smeared some dielectric grease on the plug, and I secured the wire loom to the filament feed tubes with zip ties. Will now run the same small test program to see how it does.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion