Results 1 to 10 of 102
Threaded View
-
07-09-2019, 04:58 PM #21
What would you like? I have gone back a few pages and seen your z bearings do not look secured to the plastic. They are a different style than what I am using. If you look at the picture of mine on the last page you will see I have a bolt that goes through my plastic to hold them bearings tight in place. Those are official Geeetech X carriage parts downloaded and printed from thingiverse. I have them on my home made printer also. But because that frame mounts the z rods too close to the frame I had to mirror the images before slicing and then mount the x carriage backwards so those ends would fit on my frame..
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help