Subscribe to Our Newsletter Advertise
Close



Results 1 to 9 of 9

Thread: Please help!

Threaded View

  1. 07-05-2019, 07:58 AM #6
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    I have very seldom had any problems with PLA warping except for very long models.
    T-Slot covers give my 3D Printer a little class. Found this web site that has a chart of some of the properties of 3D Printing.

    They deturmined that 70% with a layer height of 0.2 was the best overall.
    A lot of good reading anyway.
    Last edited by Roberts_Clif; 07-20-2019 at 05:58 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules