Results 11 to 12 of 12
Thread: Heatsinks
-
04-19-2014, 10:05 AM #11
Nah ramps uses a POT meter, you cant do it within the firmware,
The voltages are pretty accurate when i last adjusted em a month ago.
Well mine could burn you if its been printing for about a hour.
But only if you keep your finger on it for a minute or so i guess, it would hurt anyhow, never tryed to burn myself
Well most people that have a 3D printer from makerfarm report hot steppers.
-
04-19-2014, 03:40 PM #12
- Join Date
- Apr 2014
- Posts
- 19
You could make your own sinks from copper pipe caps or tubing, or aluminum.
Just JB Weld them on.
Anything copper or aluminum to add more thermal mass and area to it.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion