Results 1 to 10 of 102
Threaded View
-
07-01-2019, 10:08 AM #12
- Join Date
- Sep 2018
- Posts
- 11
It's not an accurate method,but I used a set square to level my gantry. I align one side on the bed then measure the gantry height on both sides. But obviously if the bed is off, the levelling is going to be a bit off too.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)