Results 1 to 6 of 6
Threaded View
-
06-30-2019, 04:25 PM #5
- Join Date
- Jun 2019
- Posts
- 3
I'm an engineering student. I'm using a Hyrel 3D Hydra printer. I increased the USM temp from 230 to 240. It printed better. I may need to increase my fans.
So the USM sticks and prints to the ABS. But it's too smeared whilst being printed. The ABS and USM can mix together at certain points. I may need to adjust the slicer settings.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion