Results 1 to 10 of 243
Thread: Any prints from the Beta team?
Threaded View
-
04-19-2014, 01:49 AM #11
- Join Date
- Sep 2013
- Location
- San Diego
- Posts
- 210
Okay, here we go:
Just a calibration cube this time, and it's still too tall, but it's getting there. I am pretty happy with this print. I made my pinhole a bit larger, this is what I got. Recalibrated my x/y and they are very close to perfect. Just too tall, and a little off center, but that is probably my fault. I fiddled with the drip mid print, because I didn't think it was working. You can't even see it the first .5 cm while it prints, that's why I haven't bothered making any videos of printing. Next time I will see how smooth a print I can get, and see if I can't get my Z dialed in just right.
The sides are just about a perfect 10mm, just as I set for this print. It is 17 mm tall though. I think my drip sizes change due to the change in drip speed.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion