Results 1 to 6 of 6
Threaded View
-
05-07-2019, 05:03 PM #4
- Join Date
- Jun 2014
- Posts
- 885
I did some additional research about your printer. It appears that it uses non-standard file formats for printing and therefore requires that you use the provided software. I apologize for my error. More searching discovers nothing regarding adjusting z-hop for that slicer software. After re-reading the user manual, I discovered a "lower bed" option but it only applies when using treelike supports, and is not what I would consider a general feature of printing.
There was a link for a user who created a program that would take g-code from Slic3r and convert it to be able to use in a Flashforge printer, but I felt it was too complex for me to suggest as a solution.
Unfortunately, I do not see an easy answer to this question.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help