Results 1 to 10 of 25
Threaded View
-
04-17-2014, 04:27 PM #22
Ok ran the marinated ABS last night and it appears to have some filament out-gassing on the finished edges. Then ran the same filament @ room humidity of 55% and you can see the difference. So conclusion do not soak your ABS in H2O but I dont think high humidity will bother it much. Ill post back in the summer when humidity hits in the 90% range..
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion