Results 1 to 10 of 11
Threaded View
-
03-22-2019, 07:31 AM #9
- Join Date
- Feb 2016
- Posts
- 68
Roberts_Clif
Thanks for the good information. I got most of what you said and I think you mean the 4.5mm in Minimium Travel. I'll check out that link also.
I'll try those settings after the current print I am doing and let you know the difference.
EDIT: With slowing down the speed with PETG and your changes I can get a reasonable first layer which is an improvement on what I was getting.
But before I go any further I will load the latest Cura which will take a while for me to get going I guess.
ThanksLast edited by Firepower; 03-22-2019 at 10:22 PM.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)