Results 1 to 6 of 6
-
03-20-2019, 07:17 AM #1
- Join Date
- Mar 2019
- Posts
- 3
First layer has "islands" that are not properly printed
First layer hascircles which are not properly filled. Happens only for the first layer.
Printer is similar to ultimaker (original)
Program used: Cura 3.2.1 (3.6 wasn't printing well)
1553082556716.jpg
-
03-20-2019, 07:34 AM #2
probably z-heaight too close to the printbed - try raising it by 0.1mm
what are you actually printing ?
-
03-20-2019, 08:26 AM #3
- Join Date
- Mar 2019
- Posts
- 3
happens on pretty much any project (except too small one) , in the middle that's a support structure
-
03-20-2019, 08:53 AM #4
-
03-20-2019, 09:00 AM #5
- Join Date
- Mar 2019
- Posts
- 3
yes, still circles . They even have different diameters.
-
03-20-2019, 09:02 AM #6
well I think it's lousy software anyway, so scrap cura and try slic3r or replicator-g with the slic3r engine.
Or do the decent thing and get simplify3d :-)
Octoprint also available, and a bunch of others.
For me cura is the most problematic of them all and given how many people have issues with it - just leave it alone and use something else.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion