Results 1 to 10 of 35
Thread: FLSUN Printer Issue
Threaded View
-
03-11-2019, 07:22 AM #22
In the video it appears that your 3D Printer is having a hard time finding the end-stop switch.
I also did not see the Z-Axis travel up or down to find the bed.
First you should test the Z-Axis the determine if it will raise and lower. Using the LCD controls.
Then you should test the Z-Axis Proximity Sensor raise the Z-Axis up in the middle then lower it using a metal spatula simulate the bed tap the Sensor.
This should cause the Z-Axis to stop moving down raise a little then continue down again this is part of the double tap to the simulated bed tap sensor again to stop.
If this work then your Z-Axis sensor is detecting the bed. If not then the Z-Axis Proximity Sensor in failing.Last edited by Roberts_Clif; 03-11-2019 at 07:28 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help