Results 1 to 10 of 13
Thread: Could my platform be bent?
Threaded View
-
04-16-2014, 07:56 PM #8
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
i hope the op meant .2mm, 2mm is huge. you really do need a perfectly flat surface. a glass build plate is nice but its actually common for those to be out of spec. i have one that .1mm high in the middle. its ok for small items but even being out .1mm is too much for large prints. now i use a mic6 alum plate. its cast, milled and stress relieved so there is no warping after repeated heating and cooling. it gives a much more even heat than glass as well.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion