Results 1 to 1 of 1
Threaded View
-
03-04-2019, 02:31 PM #1
- Join Date
- Mar 2019
- Posts
- 1
Z probe type LJ12A3-4-Z/BX onto RADDS board
Hey Guys,
I have a Z-Probe of type: LJ12A3-4-Z/BX (12V), and I want to install it onto my RADDS board.
I figured out I need to add a resistor divider with 10KΩ and 3.3KΩ in order not to fry my board.
What I didn't figure out yet is what pins I need to use for my signal pin;
Do I need to use Z_min endstop or do I need to use Servo PMW3?
The 12VDC and GND I need to install onto the PSU or maybe I could fake extruder fan 2 which I am not using for fans.
I also want to use the autolevel function so I don't need to have my bed level spot on which is kinda cool.
So do I need to change my mechanical endstop to Z_max instead of Z_min where it is installed now (or am I wrong with this)?
I know lots of questions but youtube and lots of internet information is kinda all about Ramps and lots of marlin
Thanks in common.
Cheers,
Dennis
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion