Results 1 to 7 of 7
Thread: initial success...then failure
Threaded View
-
02-19-2019, 07:04 AM #4
Hello honerboys;
I like using ThinkerCad it is an online program that is simple to use.
I also use Fusion 360 Freethough is has a steep learning curve there are many You-tube videos too teach you all you need to know.
When I first started using my 3D Printer while experimenting with all the different slicers, I too ran into this problem.
As some slicers send G-Code that allows them to change the 3D Printers settings to work better, though only if you have setup the slicer correctly for you 3D Printer.
Otherwise it will send G-Code that will cause your 3D Printer to incorrectly function.
Hours later found that all that was needed was for me to factory reset the 3D Printer.
Using Cura 15.04.6 I sent G-Code to the 3D Printer to restore the factory defaults, and all was well again until I again did the same and had to reset 3D Printer again.
M502 - Factory Reset
M500 - Save SettingsLast edited by Roberts_Clif; 02-22-2019 at 03:00 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help