Results 1 to 10 of 32
Threaded View
-
02-09-2019, 09:51 PM #32
If you look at the image, left shows the blue tape texture and a pretty tight gap. the right appears to be a top-side image with excessive gap which is contributing to poor wall bonding. The infill too is not really being "placed" if that makes sense. This is consistent with a gap that has a compensation factor applied to it. However, the two side by side prints are apples and oranges in what they portray. You can see the elephant foot splay on the far side of the part in the right image.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help