Close



Results 1 to 5 of 5
  1. #1

    trouble shooting -HE3D clog problem

    trouble shooting -HE3D clog problem

  2. #2
    Technologist TommyDee's Avatar
    Join Date
    Jan 2019
    Posts
    126
    Manual feeds, cold pulls, replacement. Problem solved

  3. #3
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,801
    which he3d printer ?

  4. #4
    Technologist
    Join Date
    Jul 2017
    Posts
    193
    Quote Originally Posted by TommyDee View Post
    Manual feeds, cold pulls, replacement. Problem solved
    ... And rebuild the hotend correctly. The PTFE tube cut square and inserted to the thermal break, and the nozzle and thermal break are tight against each other.

  5. #5
    Technologist TommyDee's Avatar
    Join Date
    Jan 2019
    Posts
    126
    Oddly enough, restrictive bowden tubes. The "tractor'd" filament becomes wide enough to add resistance to filament feed... sufficient to finally jam in the tube. It would happened consistently with some prints where a lot of pull-backs (de-string operations) would take place along with many dot depositions on supports, for instance. Where the filament would run back and forth with the driver gear over the same piece of filament half a dozen times and it flattens to a wider state than some narrow regions within the bowden tube. Add heat from friction and plastic expanding and you got a nice jam going that will have you chasing your tail for a while. Teflon is not nearly as slick as people want you to think it is. Our plastics exhibit significant stiction to Teflon.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •