Results 1 to 2 of 2
Threaded View
-
01-04-2019, 08:28 AM #2
- Join Date
- Dec 2018
- Posts
- 4
Wow, nobody has an idea?
Well I have a wild theory then...
If you look closely at my model I made a really bone-headed mistake. It's hard to tell at that angle, but I combined all meshes and then applied a bend deformer to the shield. However, I didn't even think about the shield itself not having the proper subdivisions for bending. The quick radial extrusion method I used caused the lettering and graphics to become disconnected from the faces of the shield. The result was a lot of floating objects and a single attachment point. I didn't even notice it until further inspection.
So, with all that said.. is it possible this terrible geometry threw everything off in the scaling somehow?
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)