Results 1 to 10 of 18
Thread: Monoprice Mini Delta Review
Threaded View
-
01-02-2019, 06:20 AM #17
been using the tiamat ultra filament - the stuff with nano diamonds. And been making fidget cubes with print-in-place-hinges.
So A LOT of retractions.
Been using them to fine tune the retraction settings.
I can now print a fidget cube with zero stringing and very clean hinges.
The tiamat ultra is also very tactile and a little denser than standard pla.
Attachment 12401
Attachment 12402
Attachment 12403
Attachment 12404
Based on this model: https://www.thingiverse.com/thing:1752508
I have increased the gaps between surfaces by 0.2mm. As it stands, wothout modification, the thing just solidly welds itself together into a single lump. Not sure what tolearances the chap used, but it's got to be under 0.1mm.
I also printed one at 75% size that also worked perfectly. None of them have needed any post processing.
A quick wiggle to free the hinges and they're good to go :-)
So I'm goiung to reduce the added gaps and see just how small I can make one :-)Last edited by curious aardvark; 01-02-2019 at 06:27 AM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion