Results 1 to 4 of 4
-
12-30-2018, 06:18 PM #1
- Join Date
- Sep 2018
- Posts
- 7
DaVinci Pro - "settings do not apply to material" message
Brand new at this, only about a week. Started with XYZ ABS filament, no problem. Went to Amazon PLA, no problem. Switched to Hatchbox PLA and started getting this message:
Your setting does not apply to the installed material.
I've varied the settings and get the message regardless. Anyone seen this before and can narrow down the supposedly bad setting?
-
12-31-2018, 06:49 AM #2
check in the slicer that you've got pla selected.
Thought the davinci used propriatary filament ?
-
12-31-2018, 07:07 AM #3
- Join Date
- Sep 2018
- Posts
- 7
The DaVinci uses proprietary filament and also allows for 3rd party filament, and that's where the problem was. At some point between prints, I put the proprietary filament cartridge back in the slot to store it. The printer must "see" it (there are conductors on the cartridge) even though I specified third party in the set up. Took it out and tried the print again, no problem.
-
01-01-2019, 09:17 AM #4
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion