Results 1 to 10 of 14
Thread: Fishing lures
Threaded View
-
12-27-2018, 09:15 AM #9
HI brendlo,
I decided to use Tinkercad to design a fishing lure and save it as an .STL file. Then I loaded the .STL file into Ultimaker Cura, set up the parameters for printing and saved the Gcode to my SD card. I have done two lures like this so far and they turned out pretty good considering that I am a newbie. Are you looking to do some fishing lures also?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion