Results 1 to 10 of 10
Threaded View
-
12-17-2018, 08:40 AM #8
- Join Date
- May 2018
- Posts
- 566
Yes the crystal PETG is in the picture. I also have Red and Clear.. also about the same price when I bought it. On my M2 it prints at 245 with a bed temp of 80, I have been Elmers glue stick on the glass plate as it sticks so well the the Polymide tape I normally use, it pulls the tape off when I remove the print. If starting height is not set correctly for your layer height it will give you fits sticking.. other wise it sticks like glue
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion