Results 1 to 6 of 6
Thread: 3D Printing adhesive
-
11-28-2018, 01:01 PM #1
3D Printing adhesive
What is the best adhesive for use with PLA? I need it for a Creality CR-10S printer. I looked at Magigoo but it gets some really bad reviews on its dispensing tube. I looked at 3D Gloop a few times but the PLA stuff is always out of stock.
-
11-28-2018, 02:56 PM #2
- Join Date
- May 2018
- Posts
- 566
I use jb weld plastic epoxy..
-
11-28-2018, 03:43 PM #3
lol - I think he means for the buildplate.
Dimafix is exceptionally good.
I have the bottles with the spongy dispenser - works really well :-)
lol - just realised, that's peter falk :-)
-
11-28-2018, 04:36 PM #4
I'll see where I can find Dimafix. I just checked Amazon Canada but they do not carry it. Yes, it is Peter Falk. I used to be a fan of the Columbo show. I think he did a great job in the part.
I just looked at the Dimafix site and it says:
"Dimafix is not recommended for PLA and any material that has a low print bed temperature." Most of my projects will be PLA.Last edited by Columbo; 11-28-2018 at 04:49 PM.
-
11-29-2018, 10:05 AM #5
and all I've used it for is pla :-)
I run the printbed at 65c no problems
-
11-29-2018, 03:00 PM #6
I ordered some 3DLac so I'll try that and if I have a problem I'll try the Dimafix. Thank you very much for the help. I'm waiting for the Creality CR-10S to arrive but we have a postal strike going on here so I suspect that it will be delayed.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help