Results 1 to 10 of 19
Thread: WTF is wrong with my printer???
Threaded View
-
11-25-2018, 06:08 AM #2
I had a problem like this, found it was my fault I had inadvertently Sliced the model at 3MM.
Attached is a Picture
3mm - 1.75mm.jpg
Now the fact that I was able to finish the print was a complete surprise to me.
Believe me it floored me when I found the solution was setting the correct filament diameter in Cura's slicer.
I have also experienced under extrusion because the Teflon tube inside the throat deformed.
Nozzle & Throat.jpg
These nozzles are plugged this the deformed Teflon tubing.
Guess I should have stated I have them sitting in my old Lead screw nuts.Last edited by Roberts_Clif; 11-25-2018 at 02:51 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion