Results 1 to 5 of 5
-
11-19-2018, 09:55 PM #1
No luck slicing a small, thin walled cylinder.
-
11-20-2018, 03:15 AM #2
if it's got really thin walls then you will need to enable single wall printing.
Quite often slicers leave things out if the settings say it's too thin to print.
-
11-20-2018, 11:25 AM #3
-
11-21-2018, 09:32 AM #4
-
11-21-2018, 12:50 PM #5
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion