Results 1 to 10 of 29
Threaded View
-
04-11-2014, 09:30 PM #7
Hey Geoff,
By "no leaks" I meant that the plastic cannot leak from internal junctions because it is a 1-piece nozzle. As for the dribble ("ooze"), there are ways to significantly lessen this. I haven't tested with dual extruder, but it you are using 1.75mm filament and you customize Prometheus to have a short "melt-zone" the dribble (or "ooze") will be almost entirely eliminated. So that could work...
Eric
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion