Quote Originally Posted by cbatty View Post
So my question would be, does the peachy printer use the same support material structure as an FDM printer? so will it create it at each layer, and will it use just as much material?

for example I have a cube, with the top and bottom removed. The cube then has an offest roof. will the peachy printer want to build support material underneith the roof, does it need to? and will it do it in the same way as an FDM printer? second to this. could you control the support material area. could I tell the printer where I want the support material to be and change the density by percentage?
Hey Chris, welcome to the board.

In the scenario you describe, yes, the peachy will need, and will capably print, supports for your roof. Blender is more responsible for the printing of supports than any of the peachy software though. Should work the same for FDM. I don't have an FDM though, so I am not sure!