Results 1 to 3 of 3
Threaded View
-
04-10-2014, 10:53 AM #2
Holy Cow! That is really cool! Most of that shouldn't be too hard to reverse engineer. I would like to see the locking mechanism that keeps it from launching and I would like to see how they do the seal. I'm wondering if they fill the inside with some type of sealant and let that dry before actually using the water? I don't think my prints could hold that much pressure without leaking if a sealant wasn't used???
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion