Results 1 to 9 of 9
Thread: Crashed and burned
Threaded View
-
04-09-2014, 06:45 PM #8
I uploaded the MakerFarm firmware, so that should be OK.
Thanks for the info about the Stepsticks. I haven't done that, yet.
Working from the SD card was OK. The failure must be due to the stepper drivers not being set up correctly. I'll do that later today as I have a heap of transcription and novel writing work to do today.
OME
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion