Results 1 to 10 of 26
Threaded View
-
10-24-2018, 06:40 AM #24
Yes I've still got it. But a much much better option is to use flashforge's Flashprint: http://www.flashforge.com/flashprint/
Way better and easier to use software.
Download from link below:
http://www.flashforge.com/support-ce...print-support/
Just select creator pro from the list of printers.
I've actually switched from simplify3d - which I never could get to work properly with my klic-n-print (steel framed creator pro clone).
Just use flashprint for it now.
S3d does slice a little better - but flashprint is vastly superior on dual material prints and good enough on single material that the difference isn't really worth bothering about.
My only real annoyance with flashprint is that you need to slice and save the file before you can preview the print.
No 'slice preview' only button.
But it's a massive improvement on makerware.
Plus works fine on 32bit windows :-)Last edited by curious aardvark; 10-24-2018 at 06:46 AM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion