Results 1 to 10 of 102
Threaded View
-
09-29-2018, 09:40 AM #11
cheers I'll try the knife trick.
Have ordered a screen with full size sd card reader. Just going to be more convenient that messing around with a mini-sd on the board.
Plus as I'm not using the pei sheet any more I've got ?5 extra on the budget So ordered a screen for ?11 - should get here sudnay as opposed th the same one from china for ?7 that wouldn't get here till the end of october :-)
I will no go and poke the card reader :-)
currently working on turbo fan duct for it.
I'll post mods on thingiverse.
I don't have x-axis wobble. Unless you mean the screw rods moving about ?
Going to make caps for them later/ That a quick easy design.
More for the fact that I keep putting my hand on them and then they start moving lol
****
I owe you a drink hutchouk :-)
Made a furtling tool and poked till something clicked - card reader now working :-)
Well sort of. It only recognises the card if you switch the mcahine off, insert card and switch back on. Once it's on you can remove and replace as much as you like and it just says: no card.
Still I am now running a job from the card :-)
Any other tips - let us know :-)Last edited by curious aardvark; 09-29-2018 at 10:24 AM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion