Results 1 to 10 of 102
Threaded View
-
09-28-2018, 04:43 PM #11
- Join Date
- Sep 2018
- Posts
- 11
Hi
I've just built one of these today and am slowly getting it going.
The SD card reader on my control board was faulty too, but I managed to dislodge the spring catch by putting a thin kitchen knife into it (with the power off of course). Then after "squidging" the card in a few times it started to click in as it should.
I must say I'm quite impressed with it so far. I'm currently printing out some spacers to fix the horrendous x axis wobble.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help