Results 1 to 9 of 9
Thread: Successful 1st ABS Print
Threaded View
-
09-15-2018, 05:39 PM #1
Successful 1st ABS Print
Just printed my first ABS model using a pre-sliced PLA models g-code, I did not even re-slice for ABS preheated 230C Nozzle 96C Bed selected the PLA FOB Fish g-code for Print and quickly Updated the Models PLA temperatures to the Preheated ABS values using the LCD.
And this is the Result
FOB ABS.jpg
Actually it printed better than when using PLA, as I increased the fan speed to compensate for the higher ABS filament temperature.
Allowing it to bridge better, may need to reevaluate the Fan setting I have for PLA in cura?
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion