I am a little lower where you can just feel the drag of the paper under the nozzle.

.3 Layer Thickness

.8 top/Bottom Thickness (Should be a multiple of .3 so I would change to .6 or .9)

.04 Infill overlap (I would suggest .15 - as actual layer width is about .48)

Retraction Distance 4.5 Retraction retract Speed 20mm/s

Z-Hop height mine is .075 ~ .1

Fan Speed 50%

I use Cura 15.04.6 Most of the time though have printed many with the new Cura 3.xx.x.
I like the feature where you can print the two surface walls at .14 and the a single Infill at .28 or print three surface walls at .1 and then a single at .3
(Truly speeds up print time on a fine surface model)