Results 1 to 3 of 3
Thread: prints skewing to minus x axis
Threaded View
-
08-24-2018, 10:08 AM #3
- Join Date
- Aug 2018
- Posts
- 18
i had the driver for my X motor die on my very first print. but then it just got stuck where it was jumping back and forth over a few milimeters. (the printerhead not the printer itself. Stepper motors are really reliable, as there is bascly just 1 moving part. if there is any flaws, it is usually something else. frayed wire, or as in my case, driver flaw.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion