Subscribe to Our Newsletter Advertise
Close



Results 1 to 6 of 6

Thread: Ender 3 HELP

Threaded View

  1. 07-26-2018, 05:41 AM #4
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    According to Triffid Hunter's Calibration Guide.
    " Best results are obtained when layer height < 80% of nozzle diameter, and extrusion width >= nozzle diameter. "

    I usually stay under that with the .28 though have increased to .32 on some simple objects to decrease the Print time. Can not really tell you what the Width is, but know it follows suite with Triffid Hunter's Calibration Guide.
    Last edited by Roberts_Clif; 07-26-2018 at 05:49 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules