Results 1 to 7 of 7
Thread: interlocking ideas for openscad
Threaded View
-
07-05-2018, 05:48 AM #3
if I drew it free hand, I can guarentee it would confuse more.
Mind you the basic idea is a 2 minute openscad job :-)
so you have 4 of those that just glue together. The glue i use - uhu all purpose - bonds pla as well as acetone bonds abs. Pretty sure there's a partial solunility going on as well as the actua glue component.
Anyway that's basically what I'm talking about. Just wondered if there was something better.
Actually those 7 lines are 90% of the design done lol.
The rest is just getting the screw holes in the right place :-)
Can't do that till the board arrives.
Currently about to print 4 of those 20mm square :-) Rounded the cylinders and made the hole 0.4mm larger - so 0.2 on a 'side'.Last edited by curious aardvark; 07-05-2018 at 06:03 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help