Network Printers

[AutoWiz]

So with the two boards next to each other we can see before we even begin that the base board has a slightly larger footprint than the Gen L board. This will likely mean that the mounting holes will not line up and I will have to drill a few new holes in my GEEETech frame..The nice thing is that since both boards are mks' latest architecture I didn't have to change any connectors and everything just plugged right in. everything was even in pretty much the same place on both boards. So despite the drilling that had to take place this was by far the easiest board swap I have done yet..I have also already changed all 3 fans on this printer to 24v and will change the heater cartridge to a high precision e3d ceramic heater and I will resolder the heatbed to the 24v points on the underside of the bed. This printer will be back online real soon.