Results 1 to 10 of 16
Thread: Best way of cleaning nozzles?
Threaded View
-
06-24-2018, 07:07 PM #9
Normally when the Filament is thicker after pulling it. It is because there is a gap between the Nozzle and throat cold-end. This gap allows the filament to pool causing the clog. Or in my case the PTFE tube has became deformed allow a area for the filament to pool causing a clog.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion