How many watts is the heated bed on this? I am asking because the next question is where can I find a silicone heated mat at for it? My pcb broke a long time ago and I soldered the connector back on (after it got so hot it melted) and replaced the thin wires with 14ga silicone wires. Worked great (jb weld to the rescue to weld the connector back on) but after about 14 months ABS will no longer print in it as it warps any ABS it sees and not a common type of warp either. What happens is that the middle of the part sinks in OR the ABS (mind you this is only ABS not PETG or PLA) goes in an upside down pyramid. Not sure what is happening but I will work all of that out but a nice silicone heated pad of the proper temp (thermistor is attached) will help.

Anyone managed to do this mod? Considering the first time I printed ABS with this printer (when it was brand new) it burnt up the "pc glue" that was on it YET I never exceeded the 100c it says right on it AND the stupid connector yellowed and melted I think a silicone heater pad would be the best bet so I am looking for anyone who has done this.