Results 1 to 3 of 3
Thread: 20mm test problem
-
06-11-2018, 09:41 PM #1
- Join Date
- May 2018
- Posts
- 2
20mm test problem
I'm new to 3D printing and have been having a lot of fun. I've learning a lot and my prints seem to me to be pretty good. When I print the standard XYZ 20 mm cube it looks good. I saw this one today and decided to give it a try. Below is the result. I have tried (with my limited experience) everything I can think of and the post on this test cube looks real bad. With the exact same settings I printed the standard XYZ test cube and it came out fine. Any idea what could be causing this ???
Thanks
George
IMG_0462.jpg
-
06-12-2018, 06:14 AM #2
- Join Date
- May 2018
- Posts
- 2
My Setup
I forgot to mention my setup...
Printer Anet A8
Material PLA that came with printer
Glass bed heated to 60 C
Cura 3.3.1
-
06-14-2018, 10:13 AM #3
what's the problem - and why is it on a slant ?
makes it difficult to work out what's what :-)
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help