Results 1 to 10 of 17
Threaded View
-
05-05-2018, 12:02 PM #12
- Join Date
- Mar 2018
- Posts
- 21
@3DMark, Looks good. Are you building a Filament dryer? If there's a tutorial out there that you used can you link it?
Here's some prints I did on blue tape and came out perfect. I printed one at a time and they came out pretty good. These are parts to stabalize the Z axis on my Wanhao i3. Here's a pic of the two upper supports that I printed at the same time and they came out terrible. I think though it was either a few things. 1. Partially Clogged Nozzle, this is what I think it was or could have been 2. Because my settings were set for doing 100% infill and the ones that failed were 25% infill or 3. Because I was printing more than one parts at a time, I don't see why this would matter. Or 4. Filament wasn't dry enough. I've never dried filament before and I always put the spools away in ziplock bags and deciscicant, but this roll was out for a few days. I still think it was a partially clogged nozzle. I'll try them again one at a time.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help